Description
The DYS F4 PRO V2 flight controller is a very high performance FC. It combines the PDB with the flight controller, has an integrated OSD, current meter, voltmeter, and high power BECs! With up to 6s power input and a 160A max current capability this board can easily power your next high voltage build!
Added features in the new FC
-
S5 and S6 motor control signal
-
Reverse high voltage protection circuit
-
9V/1.2A power output for the external device, such as wide voltage transmission module
-
5V/3A one-way output circuit, avoid external power supply interference
-
Circut protection for the USB port
-
Independent 3.3V/0.3A regulated output circuit
-
Flexible flat cable to connect the F4 PRO V2 with DYS F20A or F30A
Specs
-
Betaflight “DYS F4 PRO” firmware
-
STM32F405 with higher refresh rate and more function ports
-
5V 3A BEC output
-
9V 1.2A BEC output
-
3.3V 0.3A BEC output
-
Compatible all split-type escs, connect with DYS 4-in-1 esc (F20A or F30A) with flexible flat cable
-
Support BF setting software to flash and debug OSD
-
Integrated current sensor to monitor the power consumption etc in real time
-
Use remote control to view flight control parameter through OSD
-
Support SAMRT AUDIO, adjust the VTX by OSD
-
Comes with heat resistance damping ball to upgrade the stability and operation
-
3-6s lipo input, integrated PDB, max current 160A
-
Weight 10.5g, excludes the cable
-
8KHz/8KHz
-
Whole size: L 38mmX W 38mm, hole distance 30.5X30.5mm
-
Six-layer PCB board and 3OZ copper to enhance the over-current and heat dissipation
-
PDB board with reverse high voltage protection circuit
-
MCU: STM32F405 GRT6
-
IMU: MPU-6000
-
OSD: AT7456E
-
FLASH: 8M memory
-
Current sensor: 0-200A
-
When use with 4-in-1 esc, plug in the battery to supply the flight control instead of BEC
Included
-
1 x DYS F4 V2 Pro
-
1 x G10 Board
-
1 x XT60+ pigtail
-
1 x Buzzer with wiring
-
Nylon Mounting Hardware
-
4 x Rubber soft mounts
RotorBuilds
Post your build using this product to RotorBuilds.com and it will show up here! Awesome :-)
Complete builds using this part: