Airbot Omnibus Nano F4 V3 Flight Controller OSD LC Filter

Airbot Omnibus Nano F4 V3 Flight Controller OSD LC Filter
$29.99  $21.99 
Model : OMNI-NANO-F4-V3
Manufacturer : Airbot
Add to Wish List Reviews

Description

Airbots new V3 brushless AIO flight controller for FPV may be small but is packed with features including an F4 MCU.
 
Its Betaflight OSD is connected over SPI in DMA, don't know what that means? It is designed on the current proposed architecture for betaflight, it will show you any and all data you want on your FPV feed and you can change settings including tune your PIDs without taking your goggles off!
 
The board also features an MPU6000 gyro connected over SPI for fast, accurate, low noise gyro data and can support 2-6s direct input.

Specs 

  • 2-6s direct input
  • MPU6000 gyro connected by SPI for low noise, clean, high frequency gyro samples
  • BMP280 Barrometer to enable altitude hold
  • Betaflight OSD
  • Onboard voltage sensor
  • On board 5v regulator, components rated to 2A - recomended 1A max to prevent heat build up)
  • Built in L-C filter to provide clean power to FPV gear
  • STM32 F405 MCU
  • pin headers for SBUS/PPM input
  • output for 4 motors on JST-SH 1.0 
  • 25x25mm (20x20mm M3 mount holes)

Included

  • 1 x Omnibus Nano F4 V3 Flight Controller

RotorBuilds

Post your build using this product to RotorBuilds.com and it will show up here!  Awesome :-)

Complete builds using this part: 


Categories
Manufacturers
  • Shopping Cart
  • 0 items