Micro Ripper Ultra Light Brushless 2.5" Frame

Micro Ripper Ultra Light Brushless 2.5" Frame
Model : MicroRipper2.5
Manufacturer : RC Crazed
Available Options:
Add Motor Mount Bolts:
Add to Wish List Reviews


The RC Crazed Micro Ripper has one purpose, FUN! It was designed around the 20x20mm power train platform to be super compact and light weight. This is the new 2.5" variant for those of you racing in 2.5" spec races. We trimmed some weight off of the frame by using slim phast like shaped motor mount areas, thinner arms, and 2.5mm versus 3mm. The result is a very stiff, but minimalistic frame that flies really well! This frame is a pure X style made of 3k twill 2.5mm thick carbon fiber and is a single plate design.

This model is designed for a RunCam Swift Micro and VTX03. This new canopy designed by one of our local racers Jesse Stroup underwent many revisions (16 to be exact) focused on reducing weight, adding protection, and getting unlimited tilt. The canopy holds the runcam micro swift, the VTX03 in the bottom, and your spektrum or frsky micro receiver on the back.  Camera tilt is adjustable all the way up to 90 degrees :-) 

Recommended parts:

This model is an absolute blast to fly in tight spaces like back yards and small parks.  We really can't believe how fast it is on 2s but yet it is very controllable at lower speeds and in tight spaces.

To assemble this frame slide the 25mm bolts through the bottom of the frame.  Then use the included nylon nuts to build your stack.  We provide enough nuts to put 4 nuts below and 4 nuts above each board and your camera mount to keep everything nicely in place.  The neat thing about building the stack this way is that everything is fully adjustable to your liking.  If you go super low, just cut the 25mm bolts down to your preferred height.  The cicada 10A 4-1 comes with some plastic spacers so if you build with that 4-1 make sure to use those spacers to avoid pressure on the board components.  If you use ESCs on the arms you can use 20mm bolts or possibly even shorter.

Note: Use M2x5mm bolts with 11XX motors on this 2.5mm thick frame to avoid contact with motor windings.


  • Compatible with 11XX, 13XX, 14XX motors
  • 2.5" propellers
  • 2.5mm thick carbon fiber single plate frame
  • Weight with hardware and camera mount: 25.9g
  • MTM distance is: 107mm
  • Camera Tilt: 90 degrees :-)
  • Designed around the RunCam Swift Micro and Eachine VTX03


  • 2.5mm thick Frame
  • 4 x M3x25mm bolts
  • 3D Printed camera mount
  • 3D Printed camera cover
  • Battery Strap
  • 24 x M3 Nylon nuts (for above and below the boards in your stack and the pod)



Post your build using this product to RotorBuilds.com and it will show up here!  Awesome :-)

Complete builds using this part: 

  • Shopping Cart
  • 0 items